Installation
The window handle extension can be attached to all standard tilt and turn windows (almost all windows are standard tilt and turn windows).
Overview:
First unscrew the screws of the existing window handle, remove the old handle, attach the new handle with the window handle extension, screw it tight and, if necessary, adjust the distance to the window frame.
Important: The window must not jam!
Step 1:
First turn the window handle to the open position.
Step 2:
A cover cap is often present. Lift the cover cap and turn it 90 degrees.
Now the screws can be unscrewed.
Step 3:
Pull off the old handle.
Step 4:
In most cases, the square pin length is 32mm (preset for the supplied window handle extension). If you need a different length, you can adjust this by simply moving the spacer.
Step 5:
Plug in the window handle extension and screw it tight with the screws provided. If you had to change the length of the square pin, please use the screws from the removed handle. Turn the cover cap back into the cover position.
Step 6:
Finally, the distance between the window extension handle and the window frame is adjusted if necessary. The counter nut at the stop is loosened. The grub screw length of the stop can then be lengthened or shortened by turning.